When was the last time the roof of your building was inspected? If it has been awhile, the roof may have problems lurking that need immediate attention. Some roof problems cause obvious signs such as for example leaks, while some produce subtle signs that are only detectable at first glance. In either case, leaving the issues unaddressed can cost you a small fortune once you finally repair them. If the roof on your own building has any of the problems listed below, a company that specializes in commercial roofing should repair them quickly:

Buckled Panels

Roof panels buckle due to weather damage and poor installation. Regardless of the cause, the buckling allows wind to blow within the panels, making them loose. As the problem worsens, the panels start to fall off, often coming off in large sections when a storm hits. Buckled panels are perhaps one of the most commonly fixed problems by companies that perform roof repair.

Expended Screw Holes

Expanded screw holes are another problem for panel roofs. Roofing General Contractor As time passes, wind and fluctuating temperatures cause the screw holes in panels to widen round the screws that hold the panels set up. This creates a space where water can leak within the panels and soak the roof deck. Once the deck becomes saturated, the problem is costly to fix.

Blistering

Improper heating procedures and dry lapping cause hot bituminous roof systems to blister. Although small blisters seldom pose an issue, large ones can rupture and allow water to seep under the bitumen. Once the blisters form, warm weather typically makes them worse. Because of the humid subtropical climate in some regions of the country, commercial roofing frequently experiences blistering.

Ponding Water

Blocked drains and improper sloping can cause water to gather in small ponds on a roof. Repairing a blocked drain is easy, but fixing a sloping problem is more technical. Often, installing a taper insulation system to establish a new slope is the best solution. Through the rainy season, resolving ponding water is probably the most common types of roof repair.

Loose Flashing

Flashing prevents water from seeping in the crevice where in fact the roof abuts to protrusions such as chimneys and vents. Over time, most flashing should be resealed. If it is not, leaks may cause serious damage the deck and building interior. Most flashing problems are corrected during the course of scheduled maintenance.

Missing Mortar

Chimneys and high parts of brick walls that have parts of missing mortar may cause leaks. These leaks tend to be mistaken for leaks in the roof membrane, but a thorough inspection by way of a company that specializes in commercial roofing will reveal the real problem. Most parts of missing mortar can be repaired with basic tuck pointing procedures.

Conclusion

The problems above are some of the most common known reasons for roof repair. If they are corrected early, most problems are inexpensive to fix, but not addressing them until they cause serious problems may necessitate roof replacement. Having a scheduled maintenance agreement with a roofing company is the best solution to ensure problems are detected early.